Slurry Iron Removing Filter and Conveying Machine

Slurry Iron Removing Filter and Conveying Machine

Process diagram and description

1#Scheme:

2#Scheme:

1. The slurry stored in the turnover tank is transported to the "coating machine hopper" through the "diaphragm pump, pipeline, filtered, and iron removed".

2. The parts are connected by quick-fitting parts and fixed and supported by pallets, and transferred through the control system and pipelines.

3. Special attention: The "piping valve and liquid level control" between the system and the coating machine hopper/liquid storage tank must be installed and controlled by the "demand party and its coating manufacturer", which is different from the "demand party's The coating workshop site is closely related to the coating machine purchased".

Equipment composition and capabilities

Other instructions and points of attention

1. "Shaft seal, scraper, filter element" in this system are consumables;

2. This system is only suitable for "single variety slurry and continuous production mode"; taboo "frequent variety change and intermittent production mode";

2-1. If you change the "material system", please clean up (pipeline, magnetic filter) and replace all key parts (filter element/screen) in advance, and it is better to replace the pipeline.

2-2. During normal use, ensure that there is "sufficient slurry" remaining in the pipeline to prevent air moisture from entering, so as to prevent the slurry from "solidifying"!

2-3. Dimensions 500mm*1000mm*900mm (length, width and height)